The RSS-ETS-SM1 Omni-Directional Pre-Amplified Audio Surveillance
Microphone
This is a High performance, Omni-directional,
pre-amplified microphone for fixed location security applications with 25’
pickup pattern in all directions. It has a built in limiter circuit that
automatically lowers the output level during loud sound intervals. The
flexible plastic plate mounts flush or on a single gang electrical box.
This Standard omni-directional microphone has a 25’ range in all
directions with a Selectable on/off treble boost circuit that enhances
time-lapse recordings. This omni-directional microphone connects directly to a switcher /
mixer / amplifier or any of the many interface products available in todays
market to make fast, clean connections to DVRs or remote monitoring
equipment.
The flexible plastic plate is
available in white only and is flush or surface
mountable.
•
Low noise MOSFET
pre-amplifier.
•
Adjustable
gain.
•
Line level unbalanced
output.
•
Limiter circuit
selectable on/off.
•
Easy cable run
termination.
•
Power: 12VDC @
10mA.
Included in this purchase is the following:
Warning label.
Installation instructions.
Wiring
requirements:
2 conductor
shielded (with drain wire) 22 gauge stranded. Max cable length 1500’
SM1 Specifications
-
Omni-directional 25’ pickup pattern.
-
Low noise
MOSFET pre-amplifier.
-
200Hz-16Khz
Frequency response. Significantly reduces background noise.
-
Adjustable
gain.
-
Line level,
unbalanced output.
-
Limiter
circuit selectable on/off.
-
Treble boost
selectable on/off.
-
3 position
Euro-style connector makes cable termination fast and clean.
-
Reverse
polarity protected
-
Power: 12VDC @
10mA.
-
On-board
voltage regulator and RFI filtering.
-
S/N ratio:
more than 60DB
-
Sensitivity
–45DB
-
Max cable
length 1500’
-
Flexible
plastic plate mounts flush or on a single gang electrical box.
-
Dimensions: L
4.7” x W 2.9” H 0.9”
Warranty
1 year
parts and
labor.
Made in USA
Caution
It may be
against the law to install this equipment in certain environments. It is the
responsibility of the installation company and end user
to comply with state and federal laws. If you are
unfamiliar with these laws, consult a qualified
attorney.